M20 PIN POINT Micro Leak Detector


Ensure the safety and integrity of your gas systems with our high-performance Micro Leak Detector Spray. This easy-to-use aerosol spray is meticulously formulated to detect even the smallest leaks in pipes, tubes, fittings, and valves. Upon application, it produces a dense, long-lasting foam that immediately forms bubbles upon contact with escaping gas, making it effortless to spot any issues.

Key Features:

High Sensitivity Formula: Capable of identifying micro leaks that other methods might miss. Versatile Application: Suitable for use on natural gas, oxygen, air, CO2, and refrigerant systems. Non-Toxic and Non-Flammable: Safe for use in a variety of environments, including industrial and residential areas. Clear, Non-Staining Foam: Leaves no residue, ensuring clean and clear application surfaces. 360-Degree Spray: Works effectively from any angle, making hard-to-reach spots accessible. Perfect for routine maintenance or emergency inspections, this detector spray is an essential tool for HVAC technicians, plumbers, and safety inspectors. Enhance your maintenance toolkit with our Micro Leak Detector Spray and tackle leak challenges with confidence and precision.



Directions for Use: Spot On Micro Leak Detector Spray

Ensure the area to be tested is clean and dry before application. Follow these steps to effectively use the Micro Leak Detector Spray:

Shake Well: Before using, shake the can vigorously for at least 10 seconds to mix the contents thoroughly.

Test Spray: Perform a short test spray in a safe direction to ensure the nozzle is clear and the spray is working properly.

Apply the Spray:

Hold the can upright and spray from a distance of about (15-20 cm) directly onto the suspected leak areas. Coat the joints, connections, and any potential leak points with a generous amount of foam. Ensure complete coverage for effective detection.
Observe: Watch for the formation of bubbles which indicates the presence of a leak. Allow the foam to settle for at least 5-10 minutes for slow leaks; larger leaks will show almost immediately. If no bubbles form, it suggests there are no leaks; however, recheck to ensure all potential areas were covered. Identify and Mark Leaks: Once a leak is detected (noted by bubbling), mark the spot for repair. Take necessary precautions if the leak is significant to prevent any hazard. Clean-Up: Wipe off the foam with a damp cloth once testing is complete. Ensure that the area is left clean and dry. Storage: Store the can in a cool, dry place away from direct sunlight and heat sources. Ensure the cap is securely fastened to prevent accidental discharge. Safety Tips: Always wear protective gloves and glasses when using the spray. Use in well-ventilated areas to avoid inhalation of vapours. Do not use near open flames or hot surfaces as pressurised cans are flammable. By following these directions, you can safely and effectively use the Micro Leak Detector Spray to maintain the integrity of your gas systems and prevent potential hazards.

Additional information


2.5L, 750ml


There are no reviews yet.

Be the first to review “M20 PIN POINT Micro Leak Detector”